Download and install Driver SATA/AHCI Acer Aspire 3410

if you use a laptop Acer Aspire 3410, and you have a problem hard drive is not detected when installing Windows XP, you have to do is install the drivers sata / AHCI to be able to continue the installation, Before you start to install Microsoft  Windows XP  operating system, you will need an optical drive, a USB floppy disk drive, a blank 1.44MB floppy diskette, and Microsoft Windows XP  Professional/Home Edition Setup Disc (bootable). 

  • Extract AHCI F6 driver files to a blank 1.44MB floppy diskette. 
  • Connect the USB floppy drive and then boot up from the Microsoft  Windows XP  Professional/Home Edition Setup Disc to install operating system. 
  • At the beginning of the operating system installation, press [F6] to install a third party SCSI or RAID driver. 
  • When prompted, select 'S' to Specify Additional Device. 
  • Insert the floppy diskette you created in step 1. 
  • At this point you should be presented with a selection for one of the following controllers listed depending on your hardware version and configuration for AHCI Controllers: 
  •  Select [Intel(R) NM10 Express Chipset] 
  • Highlight the selection that is appropriate for the hardware in your system and press Enter. 
  • Press Enter again to continue. 
  • Leave the floppy diskette in the system until the next reboot as the software will need to be copied from the floppy diskette again when setup is copying files. 

1 komentar:

Brad Fallon said...

The instructions were a little bit shaky from the beginning but it all adds up to a successful installation of my Acer Aspire laptop. Thanks in a million.

Post a Comment

terimakasih untuk berkomentar

Entri Populer

Followers

Mac software reviews Download internet explorer for mac Blog Directory Find me on Bloggers.com